Here is a video if you are not interested in the build details and just the want to see the result. The beer was cold. The water in the shot glass hot. Hot makes the graph go up. Cold makes the graph go down. When the graph reaches the far right of the "Etch a Sketch" the stylus moves full left and the process repeats. In the video a temperature measurement is taken (and graphed) every 750 milliseconds, but that can be adjusted to anything; one reading per hour for example.
-----
The process of driving the steppers was not trivial in the beginning. First, I had no documentation on these steppers. The second being I had no idea how "noisy" and power hungry the steppers could be. The documentation turned out not to be a big deal. Via the magic of the internet I learned they were of 4-wire, bi-polar configuration. An ohm meter is all that is needed to figure out the connection scheme.
----
Close up of one of the OKI printer 4-wire bipolar stepper motors:
-----
Driving a stepper motor requires a microcontroller. My choice for a microcontroller was the PICAXE 18M2.
-----
A stepper motor is not like a 'common' DC motor. You cannot just apply a current and have the stepper spin. The current has to be applied in sequence across the four available wires. You also have to control the polarity (direction) of the current. That said, steppers motors take way more current than a microcontroller can provide. An H-Bridge motor driver solves the problem by providing more available drive current for the stepper and the ability to switch current drive polarity.
I was familiar with the SN754410NE H-Bridge motor driver. Plus, I had some in my kit. So, originally I decided to use one SN754410NE to drive each stepper motor. This was a mistake that added much frustration. The stepper motors are incredibly noisy and current hungry. The noise caused by the steppers and energy from their back EMF (I think) caused nothing to work reliably. After seeing on a datasheet that L293D motor drivers have protection diodes and some other features, I gave them a try instead. The L293D is pin compatible with the SN754420NE so the swap was easy. After inserting the L293D's everything started moving forward as planned with controlling the steppers.
-----
Now that we can control the stepper motors via the PICAXE 18M2 and L293D's we still need to interface then some way to the "Etch a Sketch". I had a clear plastic cube thats purpose was to protect a trophy baseball. Since I didn't have a trophy baseball I dismantled the cube and used the two "C" shaped pieces to mount the steppers to with the help of a Dremmel tool and double sided sticky tape.
-----
After mounting the steppers motors, you still have to mechanically couple them to the "Etch a Sketch". Rubber hose and zip tie wraps worked perfectly.
-----
After getting the mechanicals figured out a "test" pattern was programmed into the PICAXE. The test worked on the first run so we grabbed the video camera to document the success.
-----
Now that the stepper motors make the "Etch a Sketch" draw, we still need a way to measure temperature. The PICAXE 18M2 is used to read a DS18B20 sensor (picture below) via I2C bus for this:
-----
To manually position the "Etch a Sketch" stylus, two buttons are wired into the PICAXE 18M2:
-----
After all of that it is just code and software debugging.
I have other plans for the rig. Stay tuned!
-----
If you are still with me, here is the build schematic (click to enlarge):
-----